On BMW cars
since 2007 EGS has the anti-theft ISN
code (4 Bytes)
At
installation of the used transmission geerbox it is
necessary to enter these 4 bytes in CAS
It is
possible to subtract ISN from EGS GS19D transmission by means of BMW-Explorer
For
synchronization of a transmission it is necessary to find out what system of
DME (EWS3 or EWS4) from you as there are distinctions at record in CAS ISN from
a transmission
We will
consider 2 options of the record ISN
1 GS19D
transmission binding on the car with the EWS4 system just needs to come into
CAS in
additional functions further in the record
ISN and to enter in the appeared lower window 4 bytes of ISN with EGS and to
press to Write down.
To wait for the end of procedure of record
and to allow the car to fall asleep, or to de-energize the car for several
minutes
At the following inclusion of ignition of Gerbox will automatically become attached to the car
2 At GS19D transmission binding on the car with
the EWS3 system it is necessary to execute
some actions distinguishable from 1 option.
Here ISN EGS has 4 bytes , 2 bytes from
which ISN DME .. example: 11 22 33 44 it
is EGS transmission ISN
and in him there is ISN with DME in our case
33 44. Therefore at record of a new box it is necessary
at first to enter new ISN in CAS then to
reset nut EGS_EWS-to Erase in a transmission and then again
to return old ISN with DME to CAS
2.1 It is necessary to come into CAS in
Additional. Functions further ÷òåíèå.çàïèñü ISN
further we enter new ISN in the lower window
4 bytes (we remember our ISN with DME)
further we press record the program will ask to reset EWS_EGS we answer yes.
2.2 Further we switch off ignition for 20
seconds and we include again, we go to EGS in a function further in the status
of EWS and
at the status (is present there is no Avtorization-Ok also) we see that the box is unlock now
from the car and her it is possible to
put on any car now
2.3 Further it is necessary to return old ISN
from DME to CAS. We come into CAS in Additional. Functions further read/Write
ISN
then we enter ISN_DME (that which is in
DME now) in the lower ISN_DME window (2 bytes) further
we press record, the program will ask to
Dump EWS_EGS? we answer and wait for the end of record.
2.4 After the record ISN with DME it is necessary to make synchronization
of a variable code
And then ready for use EGS