BMW-Explorer supports key programming for the
following BMW models E60,E61,E63,
E64, E65, E66, E67, E68,
E70,
E71, E72, E81, E82, E84, E87, E88, E90, E91, E92, E93, F01, F02, F03,
F04, F07,
F10,
F11, F18, F12 , F13, F25 ,
Mini Cooper R55 , R56 , R57 also Rolls-Royce.
Key
into CAS1 , CAS2 , CAS3 can be programming by 2 ways:
Programming
in the key slot directly
OR
Using
file-container previously prepared with
Hitag2
, Masterkey or Tango programmers
1st variant
Connect BMW-Explorer
interface into OBD, press the "Quick
test" button, wait until the list of the connected units appears.
select and connect to the CAS unit.
First
of all we need to check for available locked and unlocked keys.
To
do this, go to the CAS in the "extra
options" and press "Lock / Unlock keys".
Here
we see free (unblocked) key tracks.
If
you have a working key, you can unlock any desired key track number.
Next,
go to the key programming.
From
left to right we have the data of the radio
channel then the data of the IMMO
As
we see in the picture.
Click
on the left button "Program new
key" and select "type of
the key"
Then
insert blank key into the ignition slot and after of about 10 seconds new key
will be programmed into the CAS.
This
way supports about of 70% of BMW with CAS1 CAS2 CAS3.
In
other cases you should use VARIANT 2 of
the key programming procedure.
Make sure that after programming, key
value should be 002B00 for the 7936 chip
and 004B00 for the radio channel key
For keys with Comfort access it is
necessary to put value of 005B00
2nd variant
This programming variant requires Hitag2, Masterkey or Tango programmers.
Prepare file-container as explained HERE , HERE or HERE.
Connect
BMW-Explorer interface into OBD, press the "Quick
test" button, wait until the list of the connected units appears.
select and connect to the CAS unit.
First
of all we need to check for available locked and unlocked keys.
To
do this, go to the CAS in the "extra
options" and press "Lock / Unlock keys".
Here
we can see what all of the key tracks are unlocked and we can program key into
any slot
Next,
go to the key programming.
From
left to right we have the data of the radio
channel then the data of the IMMO
As
we see in the picture.
Next,
load the file-container created with Hitag2,
Masterkey or Tango by clicking on the "green
cross" on the right, and press "Write"
After successful recording, insert the key into the
ignition and start the car.
Make sure that after programming, key
value should be 002B00 for the 7936 chip
and 004B00 for the radio channel key
For keys with Comfort access it is
necessary to put value of 005B00