The program
BMW-Explorer with version 14.04.12 has the ability to reset the mileage of all
CAS installed in the E series
CASZAS(E65) ,
CAS58(E65 Faccelit) , CAS2 , CAS3 , CAS3+ , RCAS1 ,
RCAS2 (Rolls-Royce) MINI R seria
(Before
resetting the mileage you need to use the programmer to edit the mileage in the
instrument panel, and do not connect IKE until tell the program about it)
To reset the
mileage, you need to go to the CAS, in the upper right corner click Reset
mileage, then the program will enter into me programming
(ATTENTION WHEN PROGRAMMING CAS PROVIDE NECESSARY POWER SUPPLY FOR
THE CAR, CONNECT CHARGER DEVICE.
PROGRAMMING ON LOW VOLTAGE CAN DESTROY THE CONTROL UNIT AND THEN IT IS NECESSARY TO
RESTORE IT BY MEANS OF PROGRAMMATOR!!!)
1. The program
will a programming window. also will write the supply voltage of the CAS
control unit.
When the power
is low, connect the charger.
When the
programming button is pressed, the program will program the unit,
(Time of programming of CAS65 CAS260 takes
4-8 minutes … and CAS3 is about 10-14 minutes.)
After the end
of programming, the program will report on successful programming and go to the
reset menu (If the programming has passed with an error, then you need to
disconnect it from the power supply for 5 minutes and restart the programming
process)
If the CAS has
already been programmed with the help of BMW-Explorer, then the program will
skip point 1 and pass to the reset of the run.
2. The program
will write to you in the reset menu, when you need to connect the panel. (Do not connect the instrument panel before !!!)
Then the
program will write when you need to turn on the ignition!
Strictly observe the sequence!!!